...ford crown victoria to replace the heater core No, you don't have to pull the whole dash board but you have to pull a few panels....here is the steps on how to get to it and remove and replace it: ...
...block drain plugs. 3 Squeeze the hose clamps on the heater core tubes ad slide them off, then disconnect the tubes and plug them with rubber. 4 Unscrew and remove the three nuts below the windshield ...
block to hit with the hammer but make sure it is kept close to the edge of the new plug. Keeping it centered on the plug can bow the plug so it doesn't seal properly. Once you have it re-installed
Where is the engine block heater cord for 2010 Ford Edge if it came equipped with one The plug will be by the battery if equipped. doubt you have one, unless you live in Alaska or further north.
...ford Thunderbird 50th anniversary leaking coolant. Comes out were tranny and block comes together. Bottom of bell housing. Is it a freeze plug because I cannot find any spots that are wet on top of ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions