...5 i have good compression changed all of the wires plugs cap and rotor but cant figure out what the noise is. Hello Josh thank you for using FixYa for your answer my name is David. sounds to me like ...
...compression on #4 cyl I put oil in cyl and rechecked still nothing. I pulled rocker cover and everything seems OK plenty of travel on the rocker arms. Bad valve? possible valves---- listen to the ...
...low cylinder pressure due to a bad valve, check both remove the valve cover first and make sure that a rocker arm hasnt jump out of socket also while you got it off check the lifter hieght that will ...
...5. If you can't measure the difference, that is not the problem. Valves with a measurably different lift still usually run fine, requiring instruments to tell any resultant problems from that. If the ...
Question about Briggs Stratton Intek V - Twin Vertical Ohv Engine with Electric Start 22 Hp, 1" X 3 5/32" Shaft, ModelNo. 44K777 - 0027 - E1
compression stroke. when you fill air coming out of the head. make the piston come all the way to top. watch rocker arms so that they the same hieght. use a filler gauge ( .005 ) put betwen the rocker
have lost compression in one of the cylinders.have no apparent rocker arm or lifter damage.no antifreeze in the oil,?? Could be piston rings, or bad valve (cracked, bent).
ford tarus rocker arm For each valve, rotate the crankshaft until the valve lifter rests on the heel (base circle) of the camshaft lobe. Position the rocker arm(s) over the push rods, then install the
installed new oil pump and now have broken rocker arms 2001 4.6 F150 installed a new oil pump and now i have broken rocker arms. what caused the rocker arms to break THe rocker arms are broken because
...compression stroke to the top of the cylinder & adjust the num 1 rocker arms, for num 2 & 3 you do the same thing, When a cylinder is at top dead center its opposites rockers are at their ...
Question about 2011 Mule 4010 4x4
If one has no spark, replace the coil (there are 2). Replace only the bad one. Before replacing the coil, check for compression, if on is real low, pull off the rocker cover and check for valve action
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions
