Questions & Answers for: ford 500 wont crank

wont start have changed coil pack and cap and rotor button not getting any spark from coil to distributor crank position sensor, try tapping it with an extension and a small hammer otherwise check the

...ford probe idling rough and occasionally dying when you would stop quickly the rpm would go down to around 80 or lower before going back up to around 500 or stalling. Yesterday I checked all the ...

...wont start has fuel psi on filter, no code an fuses good pulled top filter turned key on filter filled can here pump running sounds like high pressure oil system problem if there is an internal leak ...

...Ford 500 sounds like it wants to start, but it wont "catch". these are somethings to check battery discharged or battery terminals loose or corroded (smile out of gas) cowl pack and you do not have ...

...500 dollars later. Definetly not.. Ive stuck by GM and will argue with a ford owner till the very end about who's better.. but this 3.4 is starting to make me think otherwise. Should have never got ...

...Ford Explorer that wont run. It cranks and if I give it gas it will start but it doesnt idle at the 500 it should idle at it just dies. Ive read about the IAC and taken a look at it, its missing the ...

wont start when cold out If your vehicle is fuel injected the problem you describe could be result of a few different things: 1) Check your Idle Air Control (IAC) sensor/motor. This sensor is located ...

...ford.On a second note,the pcm <#3w4a12a650dh>no longer made,the only code they got was that the car goes into theft mode therfor there is no comunication ,between comp/engine.Need help pls tks. ...

...wont start i can here it clicking sounds like the starter but im not sure. Tried jumping it but it did nothing. Go under and jumper the solenoid wire to the positive batter cable at the starter and ...