Questions & Answers for: ford 4 fuel rail removal

Question about 2004 F350

1 Answer

...fuel pressure gauge that also has a bleeder valve on it (2)disconnect the negative battery terminal (3)remove the intake manifold service cover (4)remove air intact duct between the air cleaner ...

Ad

...ford expedition Removal & Installation Removal: 1. Disconnect the negative battery cable. 2. Relieve the fuel pressure. 3. Raise and support the vehicle. 4. Remove the fuel tank; refer to the ...

Ad

...ford escort 1.8 to a 2.0 You'll need the engine computer harness from the 2.0 and you'll have to remove the 1.8 harness and replace it with the 2.0 harness. Both fuel systems are return style so ...

...ford 6.0 liter diesel engine? V8 6.0L DSl Turbo VNP 1. Remove the valve cover 2 disconnect the fuel injector electrical connector 3 remove the bolts and the high-pressure oil rail 4 Caution, Do not ...

Question about 1989 Crown Victoria

2 Answers

...fuel rail from the block/manifold 4. wiggle and pull the rail unit from each side carefully as not to damage the injectors 5.one at a time remove clip that retains injector to rail and separate from ...

Question about 1993 Explorer Limited

1 Answer

...fuel rail off of the lower intake and the six injectors. Note the orientation of the injectors beforehand. 3. Remove all six injectors and discard all 12 o-rings. 4. Thoroughly clean all gasket ...

Question about 2003 Crown Victoria

1 Answer

...rail to get to the ignition coil, and I have the two little bolt nuts out already...? do not remove fuel rail use a flex extention and a 1/4 drive 8 mm scocket , remove bolt then gently pull coil ...

...ford taurus 3.0 dohc coding miss fire in cylinder 4. I have had the plug and coil replaced in that cylinder. Also had a compression check done they said it had 100 pounds???? What ever that means. ...

Question about 2000 Taurus

1 Answer

ford mustang GT 4.6L If you're replacing with a stock intake it's a pretty straight forward job...drain coolant, disconnect battery, remove belt, remove alternator and bracket to intake manifold, take

...two different sizes remove .look at fuel rail you will see mounting brackets remove bolts x 4 then wiggle and slightly pull up be careful not to loose seals or damage injectors then remove

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...