...Flotec 3/4 HP submersible pump, it was already here when we moved in, we have lived here for 3 yrs, so we dont know how old it is. After living here for 2 yrs, it started to get very noisy, like a ...
Question about Corrosion Resistant Shallow Well Jet Pump 1/2HP, 8GPM
flotec waterpress inox 1000 is UTMOST NOISY Noise in shallow well pump is normally associated with worn our motor bearings. Just replace the motor bearing to surely correct the problem.
Question about Simer//Omni 2957 Submersible Sump Pump with Piggyback Tethered Vertic
Motor Hums - Replace bearing Pump needs to be hand started a, quick "twist" before it spins on it's own. You will probably need to change your start capacitor if this is an induction motor.Please come
Question about Corrosion Resistant Shallow Well Jet Pump 1/2HP, 8GPM
Foltec 4012-10 motor get hots and kicks off When I install the pump it works for about couple of minute but suddenly its turns off. The motor was real hot!!! I couple of minute later I connected again
Question about Corrosion Resistant Shallow Well Jet Pump 1/2HP, 8GPM
...Flotec shallow well pump. The motor is buzzing but it will not turn. could be bad bearings,obstruction in impeller,low voltage,failing capacitor. motor burned itself out. i have the same pump.the ...
...which causes it to squeal. A pump seal is not too too hard to replace. But if your pump is squealing with a "grinding" noise as well, then that sounds like bearings. At that point look for another ...
...Flotec pump did not resume irrigation during manual switch over to another spray field. While checking it I found that the hum (attempt to start) apparently shut down by the thermal switch. While ...
Question about 1 - 1/2 Sprinkler Pump Composite Quick Priming High - Capacity 115/230v
flotec 1/12 sprinker pump runs 5 sec. and trips breaker Hi, The pump is seized up... you can try to open it and get it spinning... make sure that there is nothing stuck in the impeller... other then ...
...Flotec doesn't seem to be doing as well for the same size pump, inlet hose, etc. All plumbed the same but doesn't work. Thanks for any help or guidance. Don pressure in centrifugal pumps ...
motor is too noisy Pump is working fine but it has become very noisy when runing It is probably the bearings that are failing. They should be replaced or replace the pump.
Usually answered in minutes!
1,998 Questions
1,006 Questions
778 Questions
1,057 Questions
700 Questions