Questions & Answers for: Chevrolet K2500 floor fan

...floor it, the engine stumbles a bit but immediately revs up strong. This is after the engine has warmed up after 15 minutes idling. When I put it into drive, it dies. No backfire, just stumbles and ...

...Fan started acting up, lost 1,2,3 speeds and now only have 4th. It's a plow truck and I have to have my defrosters LOL It is under the dash next to where your passenger feet would be on the floor ...

blower fan runs when truck is turned off. replaced ignition swith last night. no change fan relay is stuck or the resistor needs replcing

1986 k2500 has new clutch, master and slave cyl. pedal goes to floor after truck been driven 10 or so miles. but will pumpup if you push it several time and work fine for a while??? slave cyl needs ...

1994 k2500 idles fine, dies when i hit gas pedal. will restart if gas is to floor. will idle fine, but will only operate at high revs after restart. as soon as pedal is pressed, engine dies. no check ...

...fan works, heat and ac works, the floor vents and dash vents work but cant get any air to blow out of the defrost vents. help i have replaced the control panel, still have the same problem Your ...

1989 full size blazer with 350 TBI. Starts when cold if I push pedal to floor and won't start at all if I dont floor it. Then motor starts to load up with lots of black smoke out of exaust and stalls ...

...when barely feathering the throttle but if you need the power for any reason its just not there. Floor it and it will hesitate, and then slowly, very slowly begin to accelerate. Plus when in park, ...

...across from left where is it located exactly? rear of brake fluid reservoir is empty & pedal to floor fluid is leaking on frame refil and have someone push brake while you look under ...

brake peddle goes to the floor. replaced both wheel cyl both brake calipers as well as brake booster. I know there is no air in lines and all bleeders had good pressure. there's still air in it or ...