Bostitch Flooring Stapler is making dents We are using a Bostitch Flooring Stapler to install 1/2" hardwood flooring. The small metal "pads" on either side of the staple slot are creating tiny dents ...
...floor. Vacuum the area to prepare for the new board. Lay the new piece next to the opening and mark the length. If this is end match, t&g at teh ends cut the ends square. I mark heavily and leave ...
...floor board I have placed a shammy under the floor mat to soak up alot of water on several occations.There is alot of water(no smell or odour of the water) on the driver's side floor board. I am only ...
...floor board on driver's side of 05 Chrysler 300 while sitting in driveway; appears to be coming through door. Could it be a floor plug missing and how would the would water travel up into the ...
floor board on 1999 GTI rotted out on passagers side in back The metal floor board rotted out on passengers side of a 1999 Gti and won't pass inspecition. Where can I get a part to replace ...
...floor board or sub-floor. Throughout the last century (and even prior to it), most sub floors where usually installed with nails and as a consequence, over time the nails are pried up with wear, ...
water in floor boards of chrysler lhs water is getting in car somehow but only in the floor boards what would be the cause of this Hi Jessca,is it the front or rear floor boards that are wet?Also,what
Question about 2005 Santa Fe
floor board stays wet losing coolant regularly evn when it hasn't rained inover a week or two just the floor carpet upper portions are dry floor board stays wet losing coolant regularly evn when ...
Question about Bostitch MIIIFN Flooring Nailers
board, and dependably permit a 1/8-inch hole between boards. Recheck your work: Hardwood floor refinishingis very important after the installation. After all walk on the floor to check if there is any
Question about Bostitch MIIIFN Flooring Nailers
...floor Depends on what thickness of plywood you have and what flooring you are going to put down. Old school used 3/4" particle board over 5/8"plywood. ...particle board Is so susceptible to so many ...
Usually answered in minutes!
191 Questions
163 Questions
151 Questions
96 Questions