Need to set floats on an xj 700 How do i set the floats on a 1985 Yamaha xj 700N Maxim? with the float bowl off and holding the carb level, adjust the float where it is level and the jet is up enough ...
...too heavy. Replace float. New carb, check float setting,can be set too high from factory. Check carb bowl and under needle for trash. Any trash in bowl or under needle, clean snd add fuel
Float setting for BS34ss carb I need the procedure and measurment for float in my 1980 Suzuki GS450 with BS34ss carbs I have a set my float to 22.0 +- 1.0 for a Mikuni carb. To set floats, drain the ...
...float height setting for a 1984 harley davidson ironhead sportster with stock carburetor With the float bowl off and the float assembled in the carb, hold the carb on it's side with the needle and ...
...the height to 0.413-0.453" from the carburetor flange surface to the top of the float. I usually try to set the float at the lowest fuel level setting with would be the 0.453" setting. Good Luck ...
...float setting for 1988 GL1500? Per Clymer, it should be set to 0.31 which is higher than the setting when disassembled. Does float setting take into consideration the ridge on float or should setting ...
to set the float level or it will be wrong. Greater than 20 degrees will collapse thew pin return spring, less than 15 will not set float properly on needle. Then setting must be 0.413 to 0.453 inches
Question about 2005 XL 883 Sportster
...for about a month now when u turn on fuel it leaks out if the over flow tube what could cause this Floats not set right. Float needle worn. Dirt keeping float needle open. Clean out carb, adjust ...
...float setting Engine is flooding and running rough. Husband needs to know the float setting and jet screw or screws setting for choke the float doesnt have a setting,if it has gas in it,then it will ...
Question about 2005 XL 883 Sportster
float setting,how to set float on a dirt bike. i would like to know inches i took carb off to clean so i need to set the float.there is gas running out the drain tub The float hight does not change it
Usually answered in minutes!
652 Questions
681 Questions
595 Questions
586 Questions
644 Questions