Questions & Answers for: flexplate bolts torque

...2whl dr 1988 GMC jimmy. does the torque converter bolt to the flywheel. You'll have to remove the torque converter to flexplate bolts and push the converter back a little when you pull the trans.

...flexplate is hooved out in the center where it bolts up to the end of the crankshaft. I don't know if that side should be toward the crank or the torque converter the dish in the center of the ...

...connect the flywheel to the crankshaft If it has an automatic transmission the flexplate or flywheel has 6 bolts to connect it to the crankshaft and 4 more bolts to connect to the torque ...

BOLTS AROUND THE CRANK BREAK THE FLEXPLATE. WHAT CAN BE CAUSING IT. G'day mate , misallignment, make sure the bell housing is in good clean servicable condition also when the box is out check that the

flexplate bolts are torque-to-yield which means they are prestreched from the factory. If you take them off you MUST buy new ones. If the new ones don't come with Locktite or simular bolt lock you

...the flywheel from the torque converter on a 2001 Tiburon? Torque converters are bolted up to the flywheel or flexplate. Probably 4 or 6 bolts from the flywheel engine side into the torque

...What could that be Loose flywheel or torque mount bolts It could simply be loose fasteners that hold the torque converter to the flexplate (flywheel) or possibly a cracked flexplate. Hope this

bolts connecting the trany to the engine. They all should be easy to take out. Are you talking about the three nuts that are used to bolt the trany torque converter to the flexplate? If so, rotate the

...Bolts or Parts Lube or Sealer Torque to: Valve Cover Engine Oil 3 ft-lbs. Exhaust Manifold Anti-Seize Lubricant 25 ft-lbs. Spark Plugs No Lube or Sealer 20 ft-lbs. Flexplate (Automatic) Flywheel ...

...into position to engine while aligning the holes in the flexplate to the bolts in the torque converter. Once alignment, secure the transmission to the engine. Then tighten the converter nuts and ...