Question about CanoScan 8400F Film Scanner
CanoScan 8400F Using the 'Canoscan 8400F', when scanning slides, whether the older square ones, or the more common rectangular ones, the scanner is often not coming up with the correct 'Film Size' in
...FAU cable. One, or more, of the eight wires within this cable has fractured and unless you are handy with fine wires and a soldering iron, it's off to the scanner shop, I'm afraid. OK. I checked this ...
film" as a source Check the cable that connects to the cover at the hinge end. If this is loose, the scanner will not allow you to scan film or slides. try reloading the drivers for the canoscan 8400F
...FAU?!) cable that connects the lift-up lid to the lower part of the scanner has at least one of the eight wires within it fractured. This cable was made far too rigid to cope with the multiple number ...
...FAU CABLE IS PLUGGED IN I SEE NO LIGHT FROM THE LID TO BACKLIGHT SLIDES IN THE SCANNER . Please see my other postings (wireguy) regarding this same problem. It's caused by a faulty FAU cable. yes. If ...
Question about CanoScan 8400F Film Scanner
...FAU cable that connects the lift up lid part to the lower part of the scanner has at least one fractured wire within it. There are eight quite fine wires and the constant opening and closing of the ...
Question about CanoScan 8400F Flatbed Scanner
canoscan 8400F My canoscan 8400F is having an issue scanning film. I get this dark band vertically through the strip of film. Any idea's why? I re-installed the drivers on my mac and it has continued.
...FAU cable. One or more of the eight wires within this cable has fractured Are you sure that the reasons they gave are wrong? I mean have you cross checked to see if isn't saw. Hi! May I ask hows the ...
...FAU plug appear to be undamaged. I notice others have had same problem and ghave been unable to solve it. Hello, First unplug your scanner data cable from your pc then go to control panel then device ...
Question about CanoScan 8400F Flatbed Scanner
...Canoscan 8400F Service manual? Scanner fails to power on either with the standard Canon power brick shows 12.34 volts at the cable end or with a stansalone 12 volt supply. I'm thinking either the ...
Usually answered in minutes!
2,817 Questions
2,244 Questions
2,162 Questions
2,149 Questions
1,912 Questions