Questions & Answers for: fix saab 9 seat plastic

...Saab 9-3 would like to apply front seatcovers. Need to remove headrests but cannot figure out how... There Is A Button At The Bottom Of One Of The Silver Posts Hold It The Whole Time You Are Lifting ...

Ad

Saab 9-3, open the hood. Behind the headlamp there is a round black plastic cover; screw clockwise and pull back; there is a metal clip holding headlamp in place (9003 i believe is the halogen number)

Ad

Question about 2002 9-5

3 Answers

...Saab 2002 9-5 Saab radio no power I had this problem on my 2003 9-5 linear wagon. There are several fuses that could be blown. There are 3 fuses in the panel near the driver door that relate to the ...

...saab convertible roof? Fold rear seat forward Remove plastic cover (6 plastic clips) Remove bolts (8or9) holding motor cover Lift front of cover up (motor should be upright at this point) There is a ...

SAAB 9-5 11999 WAS RUNNING WHILE WAITING AT A LIGHT.... ALL OF A SUDDEN IT WENT DEAD... DON'T HEAR FUEL PUMP RUNNING ANY MORE HOW DO I CHECK VOLTAGES? Lift up left back seat and you will see a plastic

Question about 2003 9-3

1 Answer

...leaks but it is very evenly distributed on both sides. What could be causing this and what can I do to stop it! see here at saab forum. How To Fix Your Leaking Saab Convertible Permanently No New ...

...fix or replace the stereo amp under the drivers side seat in my 2003 Saab 9-3 Linear? Remove driver's seat. Unhook wiring harness to amp. Remove amp. Examine for obvious problems - bad connections, ...

...fix the amp (under drivers side seat) in my 2003 Saab 9-3? Remove driver's seat. Unhook wiring harness to amp. Remove amp. Examine for obvious problems - bad connections, water damage, etc. Repair if ...

Question about 1999 9-5

1 Answer

saab 9-5 bulb replacement 2012 head light Lift hood (bonnet) For RH unclip battery cover; For LH move air intake.Unscrew plastic cover anti clockwise to gain access to bulb. Disconnect wiring,undo ...

Question about 1999 9-5

1 Answer

...seat cushion-fold forwards,release plastic clip from hinge,remove wiring multiplug if applicable.Lift out cushion.(40% backrest)Tilt forward approx 20degrees,use a screwdriver to release catch ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...