Questions & Answers for: fit distributer cap

...start back whats the problem replaced cap and rotor Hi kellymcmeen I think that you may have missed replacing the weather gasket....fits between the cap and the distributer body. Best regards ...

...inside the top of distributor Top (this is not the first time a new distributer cap has very small crack) or the rotor arm is fitting the cap properly. Hope this helps Best Wishes, Malcolm

...distributer cap on my mazda 323f cant remember what order the ht leads go back on its a 1.5 1997 model 1342 or 1243 OKAY FRONT ENGINE CYLINDERS ARE 1 2 3 4 OKAY DRAW A CIRCLE WRITE DOWN NUMBER 43 TOP ...

distributer cap i cannot be of much help here as never seen one but what i would do in this case to take a rocker cover off and follow the valves ,so inlet valve closes and exahust is coming around to

...fit a 1995 astro/safari GMC v6 distributor???? You have to take the access panel off inside the van. There used to be two screws on the outside under the hood and the two clips inside that have to be ...

...the distributer. do we have to remove the distributer and will the new one just fit in without any compter diganosis debbie did you check fuse and relay and if ok it could be ignition

...to pull out one wire at a time into the new cap in the same hole position as the fixed cap, when all leads are in, remove the old cap, fit a new rotor arm by pulling up and pushing in the new

marks on crank pully and timing gear cover , fit distributer making sure rotor points to No. 1 on dist.cap rotate distributer till contacts just start to open .start engine and reset with timing light

...fit one way the distributer cup the same will only fit one way the wire they do hang loose but because of the design when engine running this wire is forever dancing hence causing over the years the ...

...Inside distributer there is what looks like a small mini coil this may new renewing not expensive Make sure you fit any new part carefully the same as the old fitting. Best Wishes, Malcolm