Questions & Answers for: fisher paykel touch dishwasher cleaning

programme stuck I can't change the programme for the top drawer of my DD603 - its on the rinse cycle and won't move to anything else. Can anyone help? Try swapping the motor controllers (computers) ...

...fisher paykel soft touch dishwasher about 10 years old. The F1 message came on and we have taken out the inside filters and cleaned enitirely., Was working fine until it came on by itself during the ...

Fisher and Paykel soft touch leaves grit on dishes after wash. We have cleaned the base filter and spray arms. We have used commercial cleaning rinses, and used vinegar wash but still leaves grit. I ...

...fisher paykel top draw does not close fully and therefore when it operates its floodsa nd the f1 code comes on. I know how to clean and reset it but not sure why the door will not close fully, I can ...

...Fisher & Paykel DD 603 has the fault code My Fisher & Paykel DD 603 has the fault code F1. I have turned the water and power off and cleaned all the filters impella and put it back together ...

...dishwasher isnt working .bottoms fine.wont start just beeps and the numbers /display is jumbled If this has stopped working suddenly then most likely the controller on the top drawer has packed up. ...

do?Sharon Take a clean damp cloth and wipe the touch swithes and the side and top edges of the dishwasher drawer. please post a comment to report back if anything changed. Will try to solve it for you

...cleaning & drying the touch pads does the trick. worked on these dishdrawers alot. problem is nearly always the control module. if u need help to replace it please reply. the lights on the panel ...

My dish drawer is stuck on the fast cycle and am unable to change cycles on control panel Take a damp clean cloth and clean the touch panel where you set the cycle. If this does not work try turnign ...

Fisher and paykal DD. Top drawer stuck on Eco and fast wash. Buttons not responding to touch. Recent warranty replacement of lid motors and since service stuck in Eco/fast wash mode. I have tried ...