...fat boy i have it almost off but dont know how to remove gas gauge off left side of tank--carburated. also the switchover valve on bottom of tank, where do the wires go to. thanks i could use your ...
...fat boy the gas gauge doesn't work. Have changed the gauge with no results. I have been told that the float is stuck. dont have a manual and would like to get a walk through on this issue. Can anyone ...
fat boy The fuel gauge is really two parts. You have a guage and a sending unit. You must have voltage going to the unit as well. On most models, the wires that supply voltage to the gauge run upwards
after 70 miles it starts acting like its out of gas Check that you have a good fuel supply Like floats /needle jets /filters main tank fuel tap and that everything is working ok .
...you will see what appears to be two fuel lines. One is supply and the other is return from the fuel pump. I believe 1999 was last year of carbed Fat Boys. Left side tank has only one fuel supply
...job as you must rotate the assembly as you take it out of the tank. Before you do this, check all your electrical connections and the gauge to make sure your problem is in the sensor. Good luck ...
...tank venting system. 2. Loose float bowl screws. 3. Damaged float bowl o-ring. 4. Improper fuel level in float bowl. 5. Worn or dirty inlet valve or seat. 6. Damaged or leaky float assembly. 7. ...
...fat boy lo 2011 disconnect fuel line to tank, remove fuel gauge wire under tank left side , 3 wire plug probably just hanging there , or tire up with a wire holder. remove front mount bolt, take seat ...
tank could be bad. The float could be stuck on the side of the tank. Sometimes this happens on early 2000's bikes. I the float is stuck, you have to go into the tank and bend it away slightly from
Usually answered in minutes!
652 Questions
681 Questions
595 Questions
586 Questions
644 Questions