Questions & Answers for: exhaust leak toyota 3 0

exhaust and your hand will get water droplets forming on it. Both of these conditions can be caused by either a blown head gasket, or a crack in the head itself. Hope this helps! Good Luck. The the V6

Ad

leak dropping onto the exhaust just behind the manafold. Distributor oil seal replaced now not leaking oil. When hot, oil can be heard dropping onto hot exhaust and burning off with white smoke. Under

Ad

...Toyota Corolla 2003; diagnosed by the autozone OBD11 SCANNER P420. I replaced the oxygen sensor and the light deleted. After driving the car for 30 miles the light came on again! What can be the ...

...Exhaust system leak. 2. Improper fuel pressure. 3. Fuel injector restricted. 4. Defective heated oxygen sensor No. 1. 5. Defective Manifold Absolute Pressure (MAP) sensor. 6. Defective Engine Coolant ...

Question about 2000 Sienna

1 Answer

...Toyota changed a section of the exhaust system and cleaned out the exhaust system, but the problem persists. I am concerned about the breathing and other health issues this defect could cause. On the ...

Question about 2000 Sienna

1 Answer

exhaust leak a leak from the back part of the exhaust (manifold?)on a 92 Cressida butam unable to access it. How do I plug it or repair it? exhaust leaks are common, and very dangerous. if parked say ...

Question about 1999 RAV4

1 Answer

...( over 100k miles they can to that) 2: exhaust leaks{cracks} near 02. and stuck at 0volts 3: dead or weak, or dirty MAF, causing illegal unmetered air. lean. 4: intake air system has gross air

...3 and 4 and also very worn valve guides.ALSO exhaust system from head to oxygen sensor cannot have the slightest leak,it will pull air into the exhaust system and the oxygen sensor will see that

...Toyota Sequoia #1 175, #2 110, #3 175, #4 180, #5 175, #6 170, #7 85 and # 8 170. What can it be? Low compression could be caused by worn piston rings or leaking valve usually the exhaust side. You ...

...exhaust system: a leak in the intake or exhaust system can cause low compression. The dry compression test you did on cylinder 1 and 2, 80 PSI and 60 PSI respectively, are not within the normal range ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...