Questions & Answers for: evap check engine light 1999

Question about 1997 GS 300

1 Answer

...CHECK GAS CAP AND IT WAS OK. WHAT DO I LOOK FOR NEXT AND LOCATION OF IT P0446 is an evap code. Most likely, you need to change the charcoal canister vent valve (CCV) under the trunk floor. Fuel cap ...

Ad

...1999 Lexus GS300. When trying to start it does not kick over. Starter is turning the engine fine. If I pump the gas pedal many times I get a choke and sputter but it will still not start. I checked ...

Ad

...check engine light gas pedal no acceleration i have a lexus gs 300 and yesterday it was raining.my acceleration pedal began to lose power and the vsc and check engine light came on I have a a 99 gs ...

...AND 6 CYLINDER ENGINE ITS LOCATION.NEAR REAR FIREWALL SIDE CYLINDER HEAD BELOW THE IGNITION COILS.CHECK THE EVAP PURGE VALVE CONTROL SOLENOID FUSE AND IT WIRES AND CONNECTOR BEFORE BUYING A NEW

1999 gs300 shows code p1349 and the engine runs really rough at idle , runs fine off idle Its a Oil Control Valve most likely. Get the valve. Its like 100 from Lexus. Mine did the exact same thing ...

Question about 1999 Gs 300

1 Answer

...check engine light and vsc light is on and when you try to accelerate there is no power. what needs to be fixed ? get about five dollars out from your wallet and go buy fuel, then wet the interior of ...

Question about 1999 TL

1 Answer

...check engine light" in back on. The mechanic recheck my car, and said there's another problem. This time, its my emission system--Code P1457. What should I do? SYMPTOM The MIL is on, and DTC ...

...CHECK ENGINE LIGHT CAME ON A FEW DAYS LATER. THE CODE SAID IT HAS A LARGE EVAP LEAK. I REPLACED THE GAS CAP BUT THAT WASN'T IT. WHAT CAN IT BE AND HOW CAN I FIX IT. EVAP leak could be the vent ...

Question about 1999 Gs 300

2 Answers

check engine light on code says evap canister any help on locating this part Sounds like your question is answered. Hi Ern, Open the  bonnet (hood) and look down behind the gearbox. You

...EVAP system. Check canister, valves, or components. (gas cap excluded because you say you replaced it) Some or all of the above could be the source of the check engine light problem. Just replace the ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...