Questions & Answers for: espresso machine pressure

...espresso machine Hi I have the above espresso machine but just lately have noticed that the front panel lights that normally "cycle" as the machine is heating and getting up to pressure, gou out very ...

...espresso machine Yes in answer to your question I had the machine serviced by a qualified Rancilio supported workshop. The problem was different as it involved replacement of the pump, but they also ...

espresso machine My Elektra micro casa lever has started getting overheated. By that I mean the temp. runs past the red on the gage. What do you think the problem is? it can be 2 problems the pressure

...machine makes a loud whistling noise when we try to make a coffee? The coffee solenoid valve can cause such a problem if it very old you must replace it or the water pressure pump if the bypass it ...

espresso machine wont work The gauge shows no pressure but the machine will push out espresso.WHat could be a seperate problem for the wands There should be a boiler pressure and water pressure guage.

...espresso machine and it has a problem with pressure buildup. Starting last night every few hours, and continuing today up to every five minutes the pressure builds up to where the gage is in the red ...

machine either from the steamer or the espresso to clean it ? its heating generating inside the machine has the problem, steam come out only when there's sufficient heat when there's heat there's also

...pressure sensor reads as 0.9bar on the display as you switch on the machine.This remains the same though the heater keeps working without cutting off.The boiler pressure setting in the configuration ...

...espresso mega 2 is not heating and boiler pressure is in 0. what is the problem and solution to this? please help. It is possible that the safety thermostat on the boiler has tripped. Reset safety ...

Espresso machine's need about 9 bars (or 9 atmospheres) of pressure to pull effectively. You also could be leaking water from somewhere. I would suggest looking around the machine next time you use it