Questions & Answers for: error code radio display

...error code i think is on the scren the letter Y Hi and welcome to FixYa, Often an error code "Y" would indicate test/diagnostic result of the antenna. A communication equipment thus equipped would ...

error 4 code on peugeot radio ive got the code for my radio but it says error 4. how can i fix it. Turn your radio on, and leave it untouched for an hour (max) It will then display ---- you can now ...

code displayed and would not play i put in some four numbers three seperate times and it stated error three seperate times then the radio displayed off and will not come on what should i do? radio has

...error code it displays error code on my radio and i dont know the code turn off radio hold # 1 and 6 buttons in turn on radio let loose buttons wright down numbers displayed call honda give vin and ...

error code displays. Refer to the following for an explanation of each error code. Er1: INTERNAL RAM ERROR Er1 indicates the transceiver has detected an error in its battery-backed up operation memory

code still error? tried putting in radio code Sounds like you have the wrong code, maybe the radio was replaced? Hold preset buttons 1 and 6 then turn on the radio. It will display the radio serial #,

...code error Does the radio work at all. or is the cd player the only issue.? most of the time you need to enter a radio code to unlock the radio. If you enter it wrong to many times it will display ...

code error how does one reset the code after a wrong code entered the radio is now displaying code error and it is not allowing any other codes to be entered its continuously displaying CODE ERROR .So

...ERROR code Was the battery power lost to the radio? Error means you need to enter the security code for the radio, check your service books for the code or you can get it from this link: Car radio ...

...error 3. I have the code but can't figure out how to reset the display to "CODE" so I can enter the 5 digit code Disconnect your battery cables, wait a few minutes, and connect back. Usually, resets ...