...engine slows down (stop lights) the light goes off. Mechanic has change oil light sensor, changed oil, said pressure is good, changed oil. light still comes on. changed sensor again, pressure still ...
...V6 ENGINE OIL PRESSURE SENDING UNIT LOCATION NEXT TO OIL FILTER. THE 4 CYLINDER ENGINE OIL PRESSURE SENDING UNIT LOCATION IS FRONT CAMSHAFT HOUSING ON THE LEFT DRIVER SIDE OF THE ENGINE
engine oil pressure switch closes when there is low oil pressure, making the sensor signal voltage low. The switch opens when the oil pressure is above 4.5 Psi, making the sensor circuit voltage high.
...oil passage. When the engine is under pressure, oil pushes against a diaphragm (or flexible partition) inside the switch. As long as the oil is pushing against the diaphragm, it prevents the metal ...
...somewhere in the pressure sensor or indicator circuit. If the pressure is low, there is a problem in the engine - either a clogged oil filter, bad oil pump, or blockage within the
...engine oil pressure or level- Open or short circuit condition- Faulty VTEC oil pressure switch- Faulty VTEC solenoid When is the code detected?The P1259 is set when there is a problem in the VTEC Oil ...
...by oil filter,it's screwed into block. ...
Question about 2001 Chevrolet Malibu LS
...engine/oil-pressure-switch/duralast-oil-pressure-switch/chevrolet/s10-p-u-2wd/2002/6-cylinders-w-4-3l-sfi/31135_652060_8450 No there is not . Engine Oil Pressure Gage The IPC uses the engine oil ...
Question about 2001 Chevrolet Malibu LS
Where is the oil pressure switch in a 2002 chevy malibu? Here is a picture of the switch, Oil Pressure Switch Do you have a 3.8L..? How To Replace an Oil Pressure Sending Unit On GM 3 8l V6
...engine oil pressure switch closes, and the signal circuit is low. With oil pressure above 4.5 psi, the engine oil pressure switch opens, and the signal circuit is high. The powertrain control module ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions