Questions & Answers for: Oldsmobile Intrigue engine mount location diagram

...location for the air pump relay of an intrigue 2000? as best as i can tell (diagram not he best) it is located in the engine compartment near the firewall. it is in what is called the auxilary ...

Ad

is ther a switch that keeps the engine from is there a switch that keeps the engine from starting if the car is not in park? yes its called a neuteral safty switch. usually mounted to the transmission

Ad

...engine block. I have removed them without dropping the starter but learned that in most cases it is easier to drop the starter down to access it. Here is a diagram for you. There you are, hope this ...

Question about 2000 Intrigue

2 Answers

...engine Fig. Location of the MAP sensor on the throttle body adapter-3.4L (VIN X) Engine Fig. The MAP sensor is located just behind the throttle body mounting base-3.5L (VIN H) engine Fig. MAP sensor ...

Question about 2000 Intrigue

1 Answer

I need to know the cylinder numbers and thier location on a 99 Olds Intrigue 3.8 engine? Here is a diagram to help assist you.

Question about 1999 Intrigue

1 Answer

...oil level indicator, heres a diagram to show you, the diagram show it with engine upside down,the sensor is near the bottom of the block right above the top of oil pan,remove a bolt and it slides

Question about 1998 Intrigue

1 Answer

Where is the car starter located in a 2002 sunfire It is on the bottom of the engine where the engine mounts to the transmission.

Question about 1998 Intrigue

1 Answer

engine mounts i need a diagram of where the mounts are located. http://www.autozone.com/autozone/repairinfo/repairguide/repairGuideContent.jsp?pageId=0900c15280217ba4 Here are some diagrams.

Question about 2000 Intrigue

1 Answer

...cover how to change rear valve gasket The 2 motor mounts that go to the radiator support hold the engine verticle,if you pull the bolts that hold the mounts to the engine you will be able to "roll" ...

...engine oil prior to installing the sensor. ?€¢ Inspect all of the connectors for any damaged terminals. Install and fully seat the CMP sensor (1) into the cylinder head. Notice: Use the correct ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...