Questions & Answers for: edger runs half throttle

...runs but need half choke and throttle, it will not run without choke, or idle. did you try fresh gas Mine does the exact same thing and has since it was new so with mine it has nothing to do with the ...

...runs but need half choke and throttle, it will not run without choke, or idle. Starts but I must keep it between choke and half throttle for it to stay running . You need to disassemble the carb. and ...

...half throttle to keep running,will not run on full throttle stalls out. You need to clean the carburetor. Disassemble the carb. and spray with carb. cleaner. If you need tip on how best to do this, ...

runs when set to full throttle setting. It starts on full throttle setting but if I move the setting to half throttle or run the motor dies. thanks for any help you may give me Dan Are you saying full

...throttle stalls out when i switch from half choke to run... will only run on half choke... Has the air filter been removed, damaged, or the airbox not seated propelry on the carbs neck, this would ...

...half throttle, if you pull the throttle lever it like floods out. If you play with it you can get it to run full throttle but once you let up it dies. any advice would be great need to rebuild and ...

increase throttle and open choke After you start it and are in the second stage of the choke (half choke ) let it run for awhile until it warms a bit then try openning choke and going to full throttle

runs on half throttle and idle dies on full throttle. unit is new When I bought a new poulan gas trimmer, I had the same problem. Solution was to return it and get another one. They come with problems

...runs at low rpm wont run at full throttle without choke pulled out about half inch have replaced gas, cleaned carburetor. still no better screw the air and gas screw in all the way, then unscrew them ...

half turns then it will run with the throttle wide open but will not idle. Those carbs are a pain. Try arousing the idle screw, turun it to the right, then try to see if it will idle. You will have to