Questions & Answers for: easy remove rusted shock

...easy disconnect the shocks lift remove the ubolt anf lift the truck untill spring loose remove bolt front and back that about it i guest the worst its lifting the truck high be carefull safety first ...

easy, but it's the best way. As far as the brake line diagram, just replace a section at a time using the old lines as your guide. You can carefully bend them to roughly match the original. They don't

...remove the shocks it self without removing the wheel, it's your preference. Good luck and keep me posted, be glad to answer any questions you may have.  Replaced air shocks on my 2000 Silhouette ...

...easy enough to replace. Depending on which way the pins were put in you may need to remove the rear panel. There are 2 white pins that hold the shock in place (one on the tub and one in the bottom of ...

...remove shock and reinstall new,,,they are easy do the same fo rthe other side and then go to the front,,,take off wheel,,, no jacking up required for front struts,,,remove the two 18mm nuts and bolts ...

...remove the rust on the inside and outside of the frame. I can attack the bottom of the frame in this same mannor but the top is going to be the harder spot to reach. Will it get by with just teh ...

...remove a stuck brake drum, would be to apply heat to the inside edge of the drum near the axil, this expands the drum for easy removel, then clean the parts before re assembly, you could try ...

...easy. On the right side of the axle remove the "E" clip from the end of the axle and loosen the cone nut and if the belt is too loose, tighten it by rotating the weld nut on the axle left side ...

...easy to remove since there is a slot in each rod holder located at each corner at the side of the tub near the bottom. You would pull up on the tub, release the top of the rods first, then reach down ...

...easy fix. Has anyone done this or know how to that can advise me? The first thing to do is to clean the machine following the manufacturer's directions in the owner's manual. I've seen a number of ...