Questions & Answers for: dw744 motor

DW744 table saw The motor sounds like it speeds up and then down, there is quite a lot of movement up and down, I really like the saw but am afraid to use it in this condition I bought it in 2002 can ...

Dw744 10 inch table saw NO reset or circuit. You can try and unplug tool and blowing into all the exposed areas of the bottom of the saw. WEAR safety goggles. Then what I would do is check the brushes

dw744 motor runs slow and smokes, what parts need replacing? probably whole motor, if the bearings started to seize up it could have caused the armature/field to burn or if you overloaded the tool the

...motor sometimes starts right away and at other times I have to use a wood stick to spin the blade and it starts the brushes in a dw744 have a ledge when they get too short that hangs up. replace the ...

...DW744 Table Saw, Motor Runs, Blade won't turn. Almost a brand new saw, has only been used on less than 10 times. I have tried to call Dewalt customer service, the machine said they are closed for the ...

runs rough makes noise and blue sparks come out motor. the motor armature is welded at the commutator and is shot,it is cheaper to buy a replacement motor than have the armature repaired I think that ...

...dw744 xe 240v if your field coil is dead,most of the time when you run the motor 1 brush spark more inspect visually for the blackened area or darker on the windings the resistance is too low to be ...

Ridgid TS24000 runs but sounds like ice in a blender. No slack in the bearings and blade spins freely. I removed motor end cap to find the problem and found sparks coming from one of the brushes. ...

how to replace motor for DW744 you could try this link it might help you out.. How to replace motor for DW744 Google Search

...dw744 and the motor started to sputter/vibrate and spark a lot. How doe I know if I need to replace the brushes? Not Much on saws but it is alot like a starter motor and if the Brushes wear down it ...