Kenmore Elite HE4t Washer I have two issues with my washer, one is that I get the SUD error message even when very little soap is added and second the estimated timer shows one minuet when it runs for
...dryer, etc. Any ideas out there before I start paying money to have the mechanics investigate, or try to find the moeny to buy a new fridge? Thanks for any help anyone can give. I have been getting ...
far as the element is concerned, if the dryer IS heating, I wouldn't recommend checking the element just yet. Heat usually indicates the element is actually turning on. Elements don't usually get weak
...far and closing the dryer ducting.if you think the venting that runs fron the inside to the outside of the hose is restricted then you can use a leaf blower and stick the tube of it in the vent hole ...
Question about WD14311RD Front Load Washer / Dryer
water runs out of it as soon as it starts going in Water constantly running down the drain, and the washing machine repeatedly topping up with water, can be caused by faulty plumbing. The washing ...
...dryer and make sure it is not kinked or pushed back to far. there is usually lint build up some where along the ducting or at the end of the duct where it vents to the outside. 3. if you have access ...
...dryer. It should push a relaxed hand gently away from the duct outlet. If you do NOT get good air flow here then the BLOWER WHEEL hub is probably broken allowing the blower wheel to caster / spin vs ...
DRYER VENT Not sure as far as pounds but it is a lot . In winter months condensation from warm air from dryer an cool air from outside causes it to stick in PVC discharge line going out if not cleaned
Question about MED5700TQ Electric Dryer
far into it, it will help the dryer do its job much better. If you can see something is broken like a belt you can order a new one and replace it. If its attached to the end of the motor the fan maybe
Question about MED5700TQ Electric Dryer
...far end of the lint screen (be sure to secure it well, so that you don't end up with duct tape also stuck in the vent). Then you can slide it in till you contact something, give a gentle push to ...
Usually answered in minutes!
1,743 Questions
1,329 Questions
1,410 Questions
1,123 Questions
940 Questions