Questions & Answers for: dryer runs slows down speeds

...runs flame ignites and then shuts down after about 215 or 20 seconds. After a minute it will re-ignite and seems to go through this sequence over and over. vent is clean, also the drum speed seems to ...

dryer runs but slows down then speeds up hotpoint aquarius ctdoop suspect brushes in motor There are no brushes fitted in the motor in these dryers.. More likely to be a worn belt, or possibly faulty ...

A SQUEAKING NOISE WHILE RUNNING AND A FINE BLACK POWDER ON THE BACK PANEL Drum bearings shot and this slowing down the drum with the motor running at full speed will eat the belt. Change both at same ...

makes a terrible noise when drying. there is a lot of rumbling and shaking going on. the bearing my have gone My gas Maytag dryer make noises when running and slow down than speed up again HELP!

...down transformer and the dryer is not working. Do you know what part we might have burned up. Thank You Jim The dryer has sone things inside that require 110 volts. Specifically the motor and the ...

DRYER SOUND I JUST BOUGHT THIS MODEL, BUT WHEN IT'S RUNNING THE SOUND ISN'T CONSTANT, IT SOUNDS LIKE IT'S SLOWING DOWN AND SPEEDING UP - IS THIS NATURAL TO THIS MODEL? I will be very happy to assist ...

...DRYER SOUNDS LIKE IT SPEEDS UP AND SLOWS DOWN you have to clean out the dryer,do this once a year if it's gas.unplug the dryer,remove the vent line,if it's a long run blow it out with a leaf ...

...dryer is making a squealing sound Your drum bearings are wearing out or the belt driving it is spinning. The drum could be binding up and causing it to slow down and brake itself. The belt will ...

...the speed on which the fan is running. It runs at high speed only. I can reverse the direction, but not stop nor slow down the rotation of the fan. That appears to be a controller issue on your

My Minkah ceiling fan will not sustain rotation when given a call to spin. It starts off initially and then slow down to barely spinning. It does this on all 3 fan settings. What might be the issue? ...