Questions & Answers for: dryer dry clothes completely

...dry clothes. Dryer (G.E) when set for optimum dry, turn the dryer on it does not complete the cycle. it stops in the middle. we need to be reset the drying cycle 2-3 times for the clothes to dry ...

...cleaned the sensor(even though I dont use dryer sheets). Any help would be appreciated. need to check your vent duct. if clogged it won't let the air flow through the dryer needed to dry your

...dry then the dryer, a completly seperate unit only dries the clothers (no water connected) so should not be able to add water. Sounds like the washer is not completing the spin cycle and the clothes ...

...dryer does not dry clothes completely and My Kenmore gas dryer (110.76662500) does not dry clothes completely and there is a gas smell coming from the vent. This is dangrous you should call a repair ...

dry,but clothes are still wet. Sometimes the dryer works fine and completely dries the clothes in one cycle. This problem may be the result of a dirty lent filter which if clogged will short cycle the

...dry clothes completely. I have cleaned the lint vent and the vent out the back. then it maybe the heat element.Is it getting hot and it may be the controll panel,there still could be sme lint stock ...

...dryer wont completely dry the clothes? Is there a blower that pulls the air through the dryer? Cause it doesn't seem to be venting the air anymore. I guess I would compare it to a sauna. The warm air ...

...dryer does not dry completely I have a Kenmore 110.66902690 electric dryer that is not drying the clothes as it should. I have to run it through multiple cycles to dry the clothes completely. I have ...

...1.5 hours to completely dry clothes. However, if it's taking you at least 3 cycles (probably 2.5 to 3 hours) to dry a single batch of clothes, then, there might be a problem with your dryer's

not dry completely, if the clothes on the outside near the drum have low enough moisture. If you have a position on the control for dryer clothes or a more dry position try using that or use timed dry