Questions & Answers for: Maytag drum weight Washing Machines

Ad

Question about PAV2300 Top Load Washer

1 Answer

...weight on one side of the drum but even if the load is adjusted the machine will continue to bounce. We have confirmed that the machine is level and the lags are adjusted correctly. the drum was stif ...

Ad

Question about Atlantis MDE6400AY Electric Dryer

1 Answer

...when that area reaches the bottom, the weight of the drum causes a clunk. a damaged belt that clunks when the tear hits the drum a collapsing drum roller(replace in pairs) each is easy to fix,

Ad

Question about PYE2300AY Electric Dryer

1 Answer

weight of the drum 'hangs' on the stabilizers. That might also be the problem with not spinning fast enough, although I think that its not spinning fast enough because there's too much water inside. I

Question about Neptune MAH5500B Front Load Washer

1 Answer

...weight. Loose tub weights are rare on this model but they cause a loud knocking noise which is often worse when the washing machine is revving up to spin and dying down from a spin (suspension ...

Question about Neptune MAH5500B Front Load Washer

1 Answer

...drum isn't turning normally. It will spin fine until we put clothes in it. It will barely turn with the clothes - but when the weight of the clothes are removed - it turns properly. Wondering if we ...

Question about MAH8700A Front Load Washer

2 Answers

...that the weight of the drum swivles back & forth on.it is made of white plastic. Some times the floor is not stable, I was told to place a sheet of 3/4 inch plyboard under the washer to

Question about Neptune MAH5500B Front Load Washer

1 Answer

...This is at all times. This is not water that you hear. It is a form of liquid ballast that stabilizes the drum and counterbalances the weight of the clothes when the machine spins the clothes

Question about Legacy Series Top Load Washer

1 Answer

mywasher is off balance during spin cycle Posssible shifting in the suspension of the drum or the failure of the shock absorbers. Look under the drum for the suspension, the counter weights and the ...

Question about Legacy Series Top Load Washer

1 Answer

during spin cycle It is possible that the drive is tight on the washer spindle and so is making the drum to agitate. You must check the free movement of the motor and washer. Also the drum suspension

Question about MAT12CS Top Load Washer

1 Answer

...of the washer with a tilt to the rear for easy drain. Also check for bearing fault if there is wobbling, check for counter weight or alignment fault of the drum if the frames are rusted.

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...