Questions & Answers for: LG drum weight Washing Machines

Ad

Question about WM-2077C Front Load Washer

1 Answer

...weight evenly around the drum and sometimes will cause an unbalanced load. If your problem is not a simple loading issue, it could be the balance sensor, loose wiring, or possibly the main control ...

Ad

Question about WFT1071TP Top Load Washer

3 Answers

...weight the load to determine the load size the drum is not turning/moving. The water cycle starts and water comes into machine and then again with wash cycle the drum is not moving. So it must be ...

Ad

Question about WM-2277HW Front Load Washer

1 Answer

...to new house, and base stays stable only ocillation is in the drum. You could have a broken strut. However, keep in mind that these units are designed for 16llbs of dry weight for optimal

Question about WM-2277HW Front Load Washer

1 Answer

...risk of a fire. Load Error is linked with too much weight in the drum. Cycle Error is limked with an uneven load. If it happens again, unplug for two hours to reset the Error Sensors. Hope this

Question about WM-2277HW Front Load Washer

1 Answer

...drum the tub doesn't move. Another symptom of a loose tub weight is grey concrete dust under the washing machine. Warning: These days most washing machines have plastic tubs and over tightening a tub ...

Question about WM-2277HW Front Load Washer

1 Answer

...Machine shakes, rattles and "walks" across the floor when spinning Possible that the drum is out of alignment, You will need to check the motor mountings, check to see if the

Question about WM-2277HW Front Load Washer

1 Answer

...drum When spinning it throws clothes to one side and drum hits the sides of machine. How do I repair this Check if the counter balance weight is still attached. Sounds like a balance ...

Question about WM-1832C Front Load Washer

1 Answer

Drum cannot turn clothes around with water in the machine Could be a lot of different things. In the one time I had this experience it was a hot pad (that's made like a coil). It had slipped through ...

...machinefor the drum to lower i itself when water is is let in yes the drum is supported on 4 rods that have springs enclosed in air dampeners so as the weight of water increases so the springs ...

...weight and how much water has to be spinned out. If you have a full load in the machine and the drum spins like the it had an arguement with the rest of the machine, then the water sensor is the ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...