Questions & Answers for: Hoover drum weight Washing Machines

Ad

Question about SE230 Front Load Washer

1 Answer

...loose and needs to be tightened. if this problem has been going on for a while the bolts holding the weight on will have snaped and the drum/weight or both will need replacing . ( ex hoover

Ad

Question about Nextra 160 HNWF 3137 Front Load Washer / Dryer

1 Answer

...on the spin cycle. Conrete weights seem very well secured - no loose nuts. When rocking the inside drum there is no play but when the machine ramps up in speed during the spin cycles it feel of ...

Ad

Question about HDC6 Electric Dryer

1 Answer

drum, not the motor. Some noise is normal. Step 3: Force a little 20-weight nondetergent motor oil (not all-purpose oil) around the ends of the motor shaft. This lubrication may stop the humming noise

weight load model number ppv 160-180 ALWAYS UNPLUG YOUR DRYER BEFORE ATTEMPTING TO DO ANY WORK ON IT. If you have to replace your drum belt and if you have a front loading machine. Remove the front of

...weight of the drum, motor and other parts will not be sustained anymore by the rollers and other structural parts located inside the appliance. The dryer will start, but it will break down after a ...

...drum which is now only held on to the back plate doesn't stress itself under its own weight. Make sure you know where the wires need to be fed. I took videos and pictures on my phone at each step. ...

to many clothes in it. Try to remove some or reposition them. Sometimes the clothes get pushed to one side of the drum during the spin cycle and all of the weight to one side is making it off balanced

Question about HDC6 Electric Dryer

1 Answer

weight switch, which senses water height in the drum. I doubt that it is the cut-off switch because water does not flow before the start cycle is pressed. Are you able to direct mne to the appropriate

...- even when there is a small load on. What can I do to fix it? Could be bearings or more likely the concrete weight at the bottom of the drum is loos give it a shake from under to check...Good ...

...drum seems to struggle to rotate. Sometimes it will, then sometimes it won't. It's like a sensor kicks in because there's too much weight. It does this both on wash cycle and spin cycle. I have to ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...