Questions & Answers for: GE drum weight Washing Machines

Ad

Question about WBSR3140DW Top Load Washer

1 Answer

...WEIGHT OF THE LOAD.......OTHER TIMES IT SPINS SLOWLY LEAVING THE CLOTHES WET Sounds like the suspension for the drum is having problems - there are usually springs holding the drum up and acting as ...

Ad

Question about DVLR223 Dryers

1 Answer

weight of the front of drum up off of the plastic slides that serve as a resting place and friction guide for drum. Then again lift drum slightly and slide belt back around the drum, put front and top

Ad

...are available through G.E or your local appliance parts house...they are fairly easy to change........Be sure not to overload your machine excesive drum weight will cause them to wear out alot ...

Question about DWSR483EBWW Electric Dryer

1 Answer

...against anything under the drum. You may also want to make sure that the conterbalance weight is not hitting the belt. Make sure that your machine is lever and that it does not walk during

...drum when in spin cycle? Remove the front cover with a putty knife placed under the top of the front lid and pressing back on the left and right retaining springs. Lift the front cover off the bottom ...

Question about Profile DPSB620ECWW Electric Dryer

1 Answer

easier to remove to gain sight of the potential problem. Make sure the power is off. You will probably find the drum rubbing somewhere and have to release the weight of the drum to check bearings

Question about Profile DPSB620ECWW Electric Dryer

1 Answer

...drum and with the weight of the wet clothes it will probably be worse than when dry. It is probably rubbing some where. Unhook the power and pull the back cover and look around carefully. Lift the ...

Question about G.e. Gtwn4950lws He Top Load Washer

1 Answer

...drum in the washer klunks/bangs in ANY brand of washer when it is spinning, your load is off balance. stop the machine, re-distribute the wet clothes so that the weight is evenly distributed, then ...

...drum bearing. The counter weight problem easy to fix once you get the top and back off and just need re-tightened. The back drum bearing is something even trained techs want to avoid. It requires ...

...drum is not self balancing, you must take care when loading it to even the weight distribution make sure that the bowl is level in all directions as a failed support insulator will cause unbalance in ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...