...front load washer just remove the 2 dozen screws from back cover..if belt is just off may be able to just reinstall ..put on motor pulley first and then turn drum pulley to pull belt on..be sure belt ...
Question about Duet GHW9150P Front Load Washer
...drum inside seems to be a bit loose and i checked in the back and in the center (bearing) is a movement also. Looks like worn out a bit. It does not seem to be tight enough. if it make noise like a ...
Question about Aquarius WD63 Front Load Washer/Dryer
DRUM WHEEL OR THE MOTOR DRIVE POSITION? ANY IDEAS PLEASE? if you have gotten that far your good now try to look at the motor it sounds like your belt might be a lil off track on the mortor shaft there
Question about ATF6000ES Front Load Washer
...track" and loose. i can move it around. It sounds like the shocks for the drum are broken. The shocks absorb the wobbling of the drum due to unbalanced loads, etc. Remove the lower front panel (with ...
drum seems to be off its track. it makes a lot of noise when spinning and shakes a lot. One of the shock absorters was broken and i replaced it. this drum problem might have been the original problem.
Question about Front Load Washer
track the drum moves all around in the spin cycle the drum spins but as it spins it bangs around the washer. (a) Open wide the front loading door. Ensure the drum is totally empty(b) Remove the top of
...make sense if the drum is stationary Sounds like you may have a short in a wire. I would open the unit and take a look. You may want to also open it and run it to see if you can track it
Question about WF218ANW 4.0 cu. ft. High Efficiency Front Load Washer
...track Drum off track It may be a suspension spring has come off or leg has broken if it is both drums off track.If it's just the inner drum then the bearings may have failed or the spider that the ...
...and drum because the seal is either damaged or off the track. If you have a top load washer, you may try to twist the agitator and then pull it out to remove it, as you would for maintenance
Question about HE2 Plus Front Load Washer
...track Your drum has disconnected from the rail in the dryer. Sometime a bolt can work its way out and the drun can get off track. Remove back of dryer and see if you can get the drum on its track and ...
Usually answered in minutes!
9,125 Questions
3,839 Questions
3,158 Questions
2,979 Questions
2,660 Questions