...drive belt, main drum bearing and mountings seem ok with no play. disconnected drain hose from drum and looked into drum cavity for loose objects but unable to see anything. if i hold the main drive ...
Question about Ariston AWD12 Front Load Washer/Dryer
...drive belt. Drum appears loose. Sounded like a coin in the drum scraping occasionally. On spin it threw the drive belt and the drum was very loose. Appears like the drive shaft has dropped a bolt or ...
Question about Ariston AWD12 Front Load Washer/Dryer
...drum. Belt drive models use a less powerful motor which is connected to the drum via a drive belt, and the difference in size between the pulley on the drum and the motor acts as a reduction gear to ...
drum drive gear. Try another known good drum assembly first. Parts can be googled and found. But, difficult for end user to replace. You have to remove all covers and fuser asm. Then gear housing from
...drive the drum or would it be another belt? No the drive belt sits around centre of the drum, you would need to remove the top of the machine to see the drive belt.The felt belt acts as a bearing and ...
...drive, can the drum be oiled no it cant be oiled,,,,you would get oil over your clothes its hard to turn becouse of the gearing from the motor through the drive belt to the drum,,,ie:the motor turn's ...
drum drive. Most likely its the drum drive gear. It is located right behind the fly wheel in the back of the machine. Once you remove the fly wheel, the drive gear is visible for inspection. Hope this
Question about Tumble Dryer Drum Front Rubber Seal For Tc481w
spin the drum by hand, it will be stiff because you're turning the motor also. The drum drive belt is around the small pully on the motor, direct drive. If it spins ok when running, there's no problem
...drum or direct drive with a transmission. 1.) You may have a component that is worn such as the drum idlers, the belt tensioner idler or the drum support rollers. 2.) You are more likely you have one ...
Question about Tumble Dryer Drum Front Rubber Seal For Tc481w
...drive, it is possible that the drum is not turning properly. Here are some steps you can take to set the ratchet on the drum: Unplug the washing machine and remove the back panel to access the drum ...
Usually answered in minutes!
9,125 Questions
3,839 Questions
3,158 Questions
2,979 Questions
2,660 Questions