...blowing. I change ac comp relay and that didn't help. i think the comp is ok as it works for a second when i first change the fuse but then fuse blows let me know what you think thanks George UNPLUG ...
...fuse on the tumble drier, my thoughts are that the airflow is being restricted.Cool air is meant to flow in the back air vent which cools the components. This causes air convection and allows the ...
...drier blows the plug fuse when switched on what is the problem please boy the list could be very long but this dyer draws a large amount of current (amps) it should be on its own circuit nothing else ...
drier,, its a thermal fuse and will blow if the machine heats up or binds in anyway,, check to be sure you have easy flow in the ducting of the drier, as this is usually what causes the fuse to blow ,
...fuse where do I go from there? Drier is a Maytag, MED 9700SQ0 the fuse part number is AP3132867, the thermister is AP3919451. The thermal fuse is blown open due to the thermistor being open (no ...
...drier & see if the fuse still blows. If it still blows, the problem is then most likely with the drum motor. If it doesn't blow, you have only to replace the heating element. Best wishes, ...
drier 2000 ml320 could have blowed fuse or faulty relay the AC compressor and low pressure switch on drier uses same circuit.also the AC control module or switch to AC could be faulty.take vechicle to
Question about TEDX640JQ Electric Dryer
...blowing the fuse in the main panel. the drier is only two years old. Most probably a venting problem and probably caused the heating element to ground out in its casing. Easiest way to verify is turn ...
Question about W1215
fuse without taking off the drier if possible. Here is a link for the service manual: http://www.cagrimmett.com/justanswer/W1113tech.pdf Miele brand in general is a bear to work on and find parts for.
Question about W1215
...blowing the 20 amp fuse under the drivers seat! Insure that the 20 amp fuse is the correct size. Might it be shown to use a 30? Otherwise, when compressor was replaced, was drier, orifice tube ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions