Questions & Answers for: drain hose oldsmobile ciera

Drain some of the fluid to prevent it from overflowing when you remove the hose. take off the clamps holding the hose.Remove the housing and thermostat. Be careful to install the new Thermostat in the

...from the pump, these are available from most autoparts stores, and cost less than $20.00. As for draining the tank the autoparts store should also have a siphon hose to help you with

hose. Drain the coolant onto a large drain pan and recycle the coolant === I just did a FREE write up on air purge from coolant system and how to detect initial state of blown head gasket at the Fixya

...Oldsmobile Cutlass Ciera V6-3100 3.1 L thermostat location need picture Just follow the top rad hose to the engine.It will end up at the thermostat housing.The thermostat is under the thing the upper ...

...do you replace the heater core of a 1996 cierra wagon 6 cyl Remove air cleaner and duct assembly. Drain coolant. Rotate engine forward on 3100 only. Both heater hoses at heater core. Right and left ...

...install need instructions on removal and replacement. Disconnect the negative battery cable and drain the cooling system. Disconnect the heater hoses from the heater core inlet and outlet ...

radiator hose if you can and have the tool or find the drain plug on the rear down side of your radiator facing the fan, loosen the plug and drain the coolant. do not mix coolant of different colors..

...drain the transmission, or you can remove the return transmission cooler line and slide a hose over the line and put the other end in a bucket and start the engine this will let the transmission pump ...

DRAIN HOSE FOR AC NOT OPEN (PLUGED) YOU SHOULD SEE IT UNDER CAR AT R/ FRONT UNDER FLOOD BOARDS FOR PASSIGER OR A LITTLE FORWARD. IT WILL BE CLOSED UNTILL WATER OPENS IT UNLESS PLUGED. FIND IT AND PUSH

...hose to where it meets the engine. The thermostat is under that "goosneck." You have to drain the coolant, remove the goosneck, scrape off the old gasket, replace the thermostat and reinstall. Follow ...