DPFE Sensor with codes PO401 And PO402 Where Is the DPFE sensor located on a 2001 Mercury Sable with a V-6 over head valve engine. The DPFE is located near the EGR valve, it has 2 very thick silicone ...
...DPFE sensor signal circuit is shorted to ground DPFE sensor VREF circuit is open between sensor and PCM DPFE sensor downstream hose off or plugged DPFE sensor hoses both off, loose or damaged DPFE ...
...DPFE sensor signal circuit is shorted to ground DPFE sensor VREF circuit is open between sensor and PCM DPFE sensor downstream hose off or plugged DPFE sensor hoses both off, loose or damaged DPFE ...
...DPFE sensor. In effect, since the failure rate is so high, if you get this code, replace the sensor and retest. When the DPFE Sensor starts failing, it gives the PCM bad information. The DPFE Sensor ...
...sensor but that's not really what it is. 4U7E-9J460AA is the DPFE sensor for the EGR system. DPFE stands for delta pressure feedback of egr. Please let me know if I may further assist you ...
...DPFE sensor circuit input above the maximum. Possible causes: -- DPFE SIG open. -- DPFE SIG shorted to VREF or PWR. -- VREF shorted to PWR. -- SIG RTN open. -- Damaged DPFE sensor. -- Damaged
Question about 2002 Expedition
...DPFE sensor (DPFE sensor upstream hose off or plugged.. aaECM detected EGR flow in a negative direction with aan Probable cause: Failed DPFE sensor(EGR pressure sensor). Open or shorted circuit ...
...DPFE Sensor Circuit HighFaulty Differential Pressure Feedback Electronic (DPFE) sensor- Differential Pressure Feedback Electronic (DPFE) sensor harness is open or shorted- Differential Pressure ...
Question about 1996 DPFE15 Ford Windstar EGR Pressure Feedback Sensor
...DPFE sensor? I'm fighting a p 0401 code. One website says that the DPFE voltage spec values for my 96 Windstar 3.8L are the same as a 2002 Mercury Mountaineer with a 3.8L I watched a You Tube video ...
...DPFE) sensor voltage through the scan tool or backprobe the Brown/Light Green (BN/LG) wire of the Exhaust Gas Recirculation System Module (ESM). Voltage should indicate a reading of 0.5-1.2 volts. 2. ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions