Question about Windows XP Professional With Servise Pack 2 (e8503040) for PC
...registry values may make your windows stop working. you should know what you are doing and you are responsible of the cosnequenses 2) a bat file is a batch file. Batch files are files that allow ...
...DOS. How to enable automatic logon in Windows NT / 2000. To configure Windows NT / 2000 to automatically login will require the registry to be edited and the following instructions to be done. Good ...
...DOS configuration files, such as the Autoexec.bat and Config.sys. Although the Registry is common to several Windows operating systems, there are some differences among them. A registry hive is a ...
...comes up with message "registry editing has been disabled by your administrator". same happens with regedit32. When i try to run edit on DOS prompt it shows it is not an internal or external ...
Question about Windows XP Professional With Servise Pack 2 (e8503040) for PC
...DOS but not windows. Please let me know if you have any suggestions. Thank you Hi Edit Registry to get back the CD ROM ...
...dos however still cannot log on this is going to be a tough one to fix. since I don't know which svchost you have deleted from the system. usually when that happen the only solution is to reinstall ...
...files, it says disk is write protected well before it reaches its capacity. Does not even let me format Mine is Zero byte. HP USB Disk Format Utility/ Editing registry / Format from Dos are
...dos mode where you need to write, "Copy d:\i386\ntldr c:\windows. However, if you have different place of your installed operating system then you will write the address of that drive. This is the ...
Question about Windows XP Home Edition
...registry file window 7. now open windows > system32 folder 8. change to " *.reg " to " all files " 9. now find and rename "sethc" file in to "sethc1" 10. now copy and paste the "cmd" file and you ...
Question about Windows XP Home Edition
...registry file window 7. now open windows > system32 folder 8. change to " *.reg " to " all files " 9. now find and rename "sethc" file in to "sethc1" 10. now copy and paste the "cmd" file and you ...
Usually answered in minutes!
19,138 Questions
12,216 Questions
7,310 Questions
7,277 Questions
5,472 Questions