...you jarred the fuser. Turn the machine off and reseat the fuser. Open the left side door, there will be 2 thumb screws. Remove and reseat the fuser, if that doesnt work you have to replace the
...like Jam at Exit Door Open Door A. When I looked at the top of the where paper normally comes from and flipped it open I found a super crinkled piece of paper, which once removed cleared the
...12 printer. I am getting a fault/ error code of 10-300. Lower right door open. But, it is closed. How can I clear the error code? include device, open lid, press [MENU], [6], [4], [CLEAR],
...open if you still get the error you are going to have to call in a tech if it starts up . start closing things till you get to when that errror comes up then repost and ill look up an answer for you. ...
Question about Document Centre 265ST Printer
032-426 Error Code. Opened Front Door, turned off machine for 60 seconds +. How can I clear error code? xerox dc260 problem error code 024-327
...Solutions for : Belt FailureRelated Fault Codes: 042-326, Solutions ranked by relevance: Open and Close the Front Door Power OFF the Machine, Wait 60 Seconds, and Then Power ...
Question about DocuMate 262 Path-Through Scanner
receive cover open error, open and close door and still get erro error 6 red light indicates cover door open, open and close door and error still there it will be from cover sensor or Main board
Question about Phaser 3300mfpv/x Print Copy Scan Fax All-In-One Laser Printer
door is open. Where is the fuser door? The fuser door is at the back of the machine. Open the door, pull down and close firmly shut. If the error persists it could be that the sensor has gone bad. The
Question about Xerox Phaser® 8860/8860MFP Extended Capacity Maintenance (30,000 Yield)
...error codes you may see and what they indicate: 9,000.44 The Ink Loader failed during operation. 9,005.49 The Cyan Ink Melt Heater is on, but no ink is detected. 9,006.41 The Magenta Ink Melt Heater ...
Question about WC 4150 NETWORK ACCOUNTING ENABLEMENT Security Kit Network Accounting
...of paper did not arrive at the preregistration sensor in time, causing a jam. To fix - Open the inverter door and clear area 14. Open the printer right front door and clear area 2. Retry
Usually answered in minutes!
2,817 Questions
2,244 Questions
2,162 Questions
2,149 Questions
1,912 Questions