Questions & Answers for: door jamb frame

door jamb; for some reason they are now angled too far out and miss the catch plate on the back of the jamb completely. I'm no expert but they don't look warped, nor does the frame that they attach to

tyre pressure You did not specify what type of application the tires are used for. If for an automobile, that information is on the manufacture's data plate on the drivers side door frame or door jamb

...door should have been set with the jamb and you wouldn't be having this problem. We used to use a sheet of plywood to square up the jamb when setting it in concrete. Worked great. Anyway, if you can ...

...door jamb and on the door. You might be able to make a minor adjustment by loosening the bottom hinge from the door jamb and placing a shim (like a piece of cardboard from a notepad or a credit card) ...

...door jamb switch? hi yes most likely the switch or the wire behind it in the door frame. Regards Dan I agree, the plastic pin on mine was broken under the rubber on the door jamb switch. But I would ...

...door jamb. Remove the strikeplate and install it on the opposite side of the door jamb. 3 Remove the Phillips screws along the inside of the door. Lift the inner door up and remove it from the outer ...

...door jamb. Gently try to tighten all screws but be careful not to over-tighten or strip the screw heads. It's possible loose screws could be causing the door to hang slightly making it fit improperly ...

where is the secondary vin number located on a 71 cuda. where on the sub frame? One under windshield drivers side dash other in drivers door jamb

...outside of the Room, so we can free trapped residents of room? you split the thin door jamb from floor to top of door frame

and pop the door

easier fix after wards that way

...door jamb problem happened to my car! The metal seat belt hasp was jammed in the door and this prevented the door fro fully fitting in its door frame. The slight misalignment created a stress on the ...