Questions & Answers for: dohc ring oil leak

Question about 1997 Neon

2 Answers

...dohc oil leaking badly from somewhere behind alternator. I pulled off valve cover, but still can't find. Where is leak coming from? Solution: Maybe. Rear main seal is probably the problem. My 1997 ...

Ad

...DOHC engine fills with oil then drips down the back of the engine? I am pretty sure it is not the oil pump "O-Ring" problem, I have already fixed that. I can not figure where the oil is coming from. ...

Ad

Question about 1995 Cutlass Supreme

1 Answer

...DOHC 4cyl The thermostat is located in the water inlet housing that is connected to the lower radiator hose. The thermostat is equipped with a by-pass valve. If the engine tends to overheat, removal ...

Question about 1995 Cutlass Supreme

1 Answer

...ring with water only. For 1.8L engines, apply a 0.09-0.12 in. (2.5-3.0mm) continuous bead of sealant to water pump and install the pump assembly. Install the water pump within 15 minutes of the ...

Question about 1999 SL

2 Answers

...DOHC has a pink ring. Lubricate the new fuel injector O-ring with clean engine oil. Install or connect the following: New O-ring seals on the fuel injector Retaining clip to the fuel injector Fuel ...

Question about 2001 DeVille

1 Answer

DOHC 8cyl Removal & Installation procedure... 1. Before servicing the vehicle, refer to the Precautions section. 2. Drain the coolant. 3. Remove or disconnect the following: Negative battery cable

DOHC        4 Cylinders 2.3L MFI DOHCCould be a number of things - you're going to end up checking the entire car.Off the top of my head:a) exhaust component has

...dohc 16 valve bike leaks fuel from the carb intake side there is no problem starting the bike. there is only smoke coming from one exhaust pipe. a very strong smell of fuel. the bike sometimes revs ...

DOHC 04 GT. First advice is to drain the system of fluid (reservoir and rack) and be careful not to snap the plastic tube attaching points. Remove the Drive belt. With the car on safety stands, remove

ring trouble on the 4th cylinder that could cause a misfire because of poor compression. The other thing that springs to mind is that there's something amiss with the valve clearances on cylinder No 4

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...