Questions & Answers for: dodge dakota shift cable adjustment

...Dakota, trans doesn't slip, but stays in first a long time. Shifts to 2nd and Drive OK. It is a little better after warming up. Fluid and filter I hope? Possible throttle valve adjustment. Very ...

...shift from 1st to 2nd, then 2nd to 3rd. I have a 2002 Dakota 2 wheel drive, automatic, just change the tranny, bought used, it works fine just don't know how to adjust my hard shift problem. Starting ...

...Dodge Dakota 5 speed. The gears are I have a 1995 Dodge Dakota 5 speed. The gears are not shifting smoothly and sometimes very difficlut when down shifting. However, when I drive slowly, the gears ...

...dodge dakota 4x4 ,it won't shift from 1 st to 2 nd unless i manually shift into neut. and ley the rpm. drop and then back into drive. i've replaced gov. sol., and gov. transducer, and the comp. still ...

dodge dakota wont start unless I hold the shifting lever up into park. it is an automatic transmision and if I try to start it without holding up on the shifting lever it is just dead Adjust the slack

...shift quality but not timing.A throttle pressure adjustment may be needed to correct this problem.The cable coming from transmission is located on the passenger side and is pulled by the throttle ...

...dakota 3.9 no pulling power going up a hill or grade acts like its not getting enough gas When you say going up a hill are you wide open throttle? Does the bucking occurs at 5300 RPM? If you are you ...

...dodge 3.9 litre dakota hy revs and takes long to shift if it shifts at all just had intake manifold gasket on bottom side replaced sounds like the kick down cable is stretched or out o adjustment. it ...

...dodge Dakota runs up to 4000 rpms before it shifts but it still idles really high after that. its a v6 3.9L automatic. I think its the shift linkage but I don't know how to adjust it. ive had ...

...dodge Dakota 94 5.2 4 wheel drive ran fine then went to go In reverse but went coward and then all gears are forward and stuck in 1 gear is this the shift solenoid It is possible that the issue you ...