DODGE STRATUS 2.4 V6 ENGINE CODE "R" Tighten bolts in sequence shown in (Fig. 23), using the following steps and torque values: Step 1: Bolts 1 - 8 to 48 Nm (35 ft. lbs.) Step 2: Bolts 1 - 8 to 75 Nm
...dodge dakota 5.0 torque specs. for heads 105 Foot pounds (Final torque) Torque sequence ------------ front | 7 3 1 5 9 | of | 8 4 2 6 10 | engine ------------ Final torque must be reached in 3 equal ...
Dodge Durango with a 318. Thank you!! Head Torque sequence Step 1: torque to 50 Ft/Lbs Step 2: torque to 105 Ft/Lbs recheck final torque in sequence. Torque intake manifold: Step 1: 12 inch/Lbs, (hand
...torque specs: 1st pass 25 ft-lbs 2nd Pass 50 ft-lbs 3rd Pass 75 ft-lbs Final Pass tighten plus (+)1/4 turn = 90-degrees BOLT ORDER: 10----6----2----3----7 9----5----1----4----8 START WITH 1 THEN 2 ...
...Dodge Stratus 2.4L SFI SOHC 4cyl the Head Bolt Torque sequence ------------ | 10 6 2 3 7 | | 9 5 1 4 8 | ------------ Step: 1 - Torque to 25 ft/lbs Steps: 2 - Torque to 50 ft/lbs Steps: 3 - Torque to ...
...dodge dakota 4x4 and need the torque setting for the 3 hub bolts on the front end also the axle nut torque setting The torque for the hub bolts is 120 ft. lbs The torque for the axle nut is 185 ft. ...
Question about 2007 Nitro R/T New Cars
...dodge nitro Remove the brake caliper and pads, You have to remove the large axle nut It has to be torqued back on. You can find that torque spec by googling axle nut torque spec for your vehicle. ...
Question about 2007 Nitro R/T New Cars
...Dodge ram 1500 3.7 liter Install the cylinder heads. Use new gaskets and tighten the bolts, in sequence, as follows: Step 1: Bolts 1-8 to 20 ft. lbs. (27 Nm) Step 2: Bolts 1-10 verify torque without ...
Question about 2007 Nitro R/T New Cars
...dodge dakota sport 3.9l eng Hi Matthew,, this is all i could find,try this link might help you. Whats the torque specs on valve cover bolts on 1999 dodge dakota sport 3... It is about 9 ft lbs, snug ...
...dodge-... Jun 27, 2009 - SPECIFICATIONS - TORQUE ; Balance Shaft Carrier Cover-Bolts, 12, - ; Camshaft Sprocket-Bolt, 101, 75 ; Connecting Rod Cap-Bolts, 27 +¼ turn, 20 +¼ ... 1 answer · Top answer: ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions