Question about KV S2025C Path-Through Scanner
...Document remains in scanner. Open door and remove document." There is no document in the scanner. Dismantled scanner, cleaned all 4 document sensors and cleaned the paper path. Reseated all sensor ...
document feeder, the check the small piece of glass as the scanner bulb remains stationary and the paper is fed by. If you are laying the paper on the glass and scanning, then you will need to look at
Question about OfficeJet 6110 All-In-One InkJet Printer
Scanner Failure Turn Power Off then On again" Before the message appears there are several seconds of noise in the right hand side of the printer. It seems as though several other people have the same
Question about Digital Science 2500D Path-Through Scanner
...document there is a line down the entire page. I've used canned air and looked around for a peice of paper stuck but the line remains. Hi, Most likely the scanner has dirt on the glass that is over ...
Question about PSC 2175 All-In-One InkJet Printer
...BG Clean the glass surface with a clean lint free cloth(which does not leave any remains) and also clean the scanner back which may affect the scanned document's ...
Question about KV S2025C Path-Through Scanner
Vertical Light Streaks on text documents, both single and duplex When scanning text documents, there are streaks on the final copy that we have scanned and saved in a pdf file. The streaks do not show
...reinstall the scanner again. Try on a different computer. If even after this the problem remains, may be the there is some hardware fault (failure of light) in the scanner. How is it in color? S. ...
Question about PIXMA MX700 All-In-One InkJet Printer
...document has a line on it When you use the adf, the scanner remains stationary at the far left side of the platen. Check and make sure that the glass is very clean there; use a damp cloth to remove ...
When feeding the visoneer strobe xp 470 with more than one sheets of documents, the first document goes through with no problems, however, the remaining documents goes through at a faster rate ...
document out carefully without applying too much force. Be sure to remove any torn parts remaining in the scanner. Close the upper unit slowly, ensuring it clicks into place. Do not force it to close,
Usually answered in minutes!
2,817 Questions
2,244 Questions
2,162 Questions
2,149 Questions
1,912 Questions