...document processor and the error light is flashing. Thats the only thing it will do. Look in the Document Processor, That is the auftomatic feed device.Look for a scrap of paper jammed in the ...
reset originals in processor Kyocera 2530 take the paper out of the document feeder... and put them back in... thats the part on the very top where you insert papers for copies...
...with the document processor of ur machine. either there is a jammed paper on it or the actuator of ur switch on the document processor is broken. quien me puede ayudar en mi copiadora a parecio ...
...document from processor" and there is definitely not a document stuck in the machine! There is a 3 inch long plastic arm under the top door of the top feeder. This is a sensor arm. It is most likely ...
document processor, please help me,thank you Do you mean that it is always jamming in the Document Feeder on the top of the copier? If this is the case, I would like to know how far the paper goes in?
...document processor." Although there is no card is locked. It sounds as if you may have something holding on one of the paper detect sensors.Try manualy pushing (carefully) a thick piece of ...
Question about FS-C2126MFP Printer
getting a error message that says close document processor The message refers to the automatic document feeder (ADF). It may require adjustment or complete replacement.
Question about "FS-3040MFP Printer, Copier, & Scanner"
reparation error c3100 for kyocera fs-3010 mfp Scanner carriage error The home position is not correct when the power is turned on, at the end of a reading process of the table and document processor.
Question about "FS-3040MFP Printer, Copier, & Scanner"
...Document Processor "" I think the message is "Reseat All Originals in Document Processor". This message apears when there was a misfeed or something like that. It means that you must put back all the ...
Question about FS-1030D Laser Printer
document processor These are notarius for having a cabling problem.the cable that runs from the d/f to the main unit go bad. It's a process to change one I would seek help by a person that has done it
Usually answered in minutes!
2,817 Questions
2,244 Questions
2,162 Questions
2,149 Questions
1,912 Questions