Questions & Answers for: disconnecting pool pump motor

pump. 2 Motor has died, how to disconnect from pump. 2 speed 1081 pool and spa, HP 2.5/.42, 230 volt. amps 11.5/4.0 The thru-bolts hold it to the seal plate and the impeller is threaded onto the shaft

motor mount. The wires in the pool cleaner probably did disconnect from the motor. You might not be able to see the disconnection, but i would guess this is the problem since you already know your son

...or pool spa store--if motor pump check pump for debris and motor for lube if u can turn shaft or impeller oil motor and work it into bearings if still not turning possible need to replace motor ...

...POOL PUMP MAKES A NOISE BUT DOES NOT PUMP WATER. WAS WORKING AN YESTERDAY. HAVE CLEANED FILTER, AND MANUALLY TURNED FAN AT THE BACK. STILL NOT WORKING?? If your pool pump is acting sluggish it may ...

...motor to the pump housing. I believe they are 1/2 or 9/16 inch stainless. Make sure you disconnet the power cord and the bonding wire before you start. Make double sure you reconnect the bonding wire ...

pool pump motor schmatic the motor shaft has some sort of gaskit fitting on it between the impeller and motor side of the housing to prevent water from passing from the impeller side of the housing to

...pool pump motor, i am having trouble disconnecting the old but working impeller housing and impeller to put on new motor. Need to take off quick, any suggestion. probably reverse thread screw and ...

...pool pump motor jacuzzi magnum force Do I have to disconnect the power to get the retaining nut, or is there something that can be removed from the pump to get the nut on? It may be easier to ...

...pump is below the level of the pool, there should be valves to stop water flow as well as the unions to remove it from the system. plan B is to describe what you hear\see and let a pro point you in ...

...pool motor aol 1-1/2 hp Dismantle to Components It depends which pump you have, on hayward super II you shut off the breaker, remove the rear motor cover, disconnect the electrical wires, then remove ...