Question about TC-P50X1 50 in. Plasma HDTV
...Direct TV. Any ideas of what the problem could be???? Flashing error codes could be the Direct tv box itself.Because tvs have problems within itself don't flashes error codes on the tv screen,the ...
...direct tv. if i turn tv on wait for av box to appear on screen then turn on direct tv box everything is ok tried another tv and it was fine just the panasonic acting up tried to hooked up only an ...
...direct tv remote to turn off my tv? I've managed to get it set up for volume but it will not turn off the tv or control the input button. Help!! You will need to contact Direct TV for a list of ...
Question about Tc-p42s2 42-inch 1080p Plasma Hdtv
I have a 2" wide vertical dark line in the center of my screen. Before you go to the dealer, try disconnecting it from the wall for 15 minutes, disconnect all inputs, then plug it back in - do not ...
Question about Tc-p42s2 42-inch 1080p Plasma Hdtv
...Panasonic plasma tv. Model TC-P42S2. Thin green line horizontal through the middle of the screen. Red and white wide horizontal line across the top. If you wish to get some details; check the site ...
Question about Tc-p42s2 42-inch 1080p Plasma Hdtv
...TV. There is no network connection available (wired or wireless). It does have a slot for an SD card to make it a 32" photo viewer. You can also update the firmware by placing the unzipped file (see ...
Question about Tc-p42s2 42-inch 1080p Plasma Hdtv
...code I checked my Panasonic tv power supply board it puts out 15v but when it starts blinking it goes to 9.6v ? Those blinks [flashes] are fault indication (Error Codes). From the number of blinks ...
Question about Tc-p42s2 42-inch 1080p Plasma Hdtv
I have a Panasonic wide screen TV (Model # TC-P42S2 If you wish to get some details; visit the site linked here. Pull up older posts. http://electronicshelponline.blogspot.com/
Question about Tc-p42s2 42-inch 1080p Plasma Hdtv
...TV that doesn't power on giving the 10 blink code. have to hold the power switch down several seconds to power off. power on again and get the same results. Page 76 of the Service manual, but ...
Question about Tc-p42s2 42-inch 1080p Plasma Hdtv
...TV TC-P42S2, no sound or picture, 10 blink code, stays consistent after several reset attempts The power LED blinking ten times is indicative of issues with the voltages on Sub 5V, Main 3.3V, DTV 9V ...
Usually answered in minutes!
2,410 Questions
2,254 Questions
1,646 Questions
1,423 Questions
1,438 Questions
