...Digital Volt/Ohm Meter (DVOM) with the black lead on the battery terminal and the red lead on the cable end ( the cable should not be touching the battery at this point). Set your DVOM to the amp ...
...digital multi-meter to its highest amperage scale. Connect the multi-meter between the disconnected battery negative cable terminal clamp and the battery negative terminal post. Make sure that the ...
Question about AMP-100 2-Channel Amplifier
...scale meter than a digital) apply to base (B) and then to C & E you should get an ohms reading. If you don't get any reading (both ways) it's dead (open) and if the meter goes full scale - it's ...
Question about Pavilion a705w PC Desktop
digital, doesn't matter. The function knob in the middle of the multimeter is set to the DC Voltage scale. The DC Voltage symbol is one straight line with a dotted line above it. (AC Voltage symbol is
...2. Open the battery compartment on the bottom of the scale. 3. Remove the old battery from the compartment. 4. Place the new battery with the "+" sign up into the battery compartment. 5. Replace the ...
...digital is fine)Set the Function knob to DC Voltage. If more than one scale set it to the 0 to 50 Volt DC scale.Test the three major voltage power rails.A) 3.3 VoltsB) 5 VoltsC) 12 ...
...scale. (Or readout if the multimeter is digital)It is brief because the Power On switch is a Momentary Contact Switch.No reading? Bad ATX power on switch,http://www.directron.com/atxswitch.htmlGood ...
Question about 100 X 0.01 Gram Digital Jewelry Pocket Scale
scale reads HHH. What does this mean and how do i fix it? It worked on mine, I pushed Mode, Power, Tare at the same time. It came up in Cal mode. I added penny's till it was 995 or so then added small
...scale and measure for resistance across the pins of the stator. You should read something around 0.1 to 0.2 ohms for a 32 amp system. 4. Then check for continuity between each pin on the plug and ...
Question about 2001 VN 750 Vulcan
...digital or with an analog meter, set it on the lowest scale...Place one lead on the clean top of the negative battery post and the other on bare metal of the chassis (fender bolt is proper)...meter ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions