Questions & Answers for: dewalt drill mains

...DeWalt 18 volt drill. i.e. the 2 main halves that screw together and once they are together its the area you wrap your hand around....hope it makes sense so far. So all went well until a very small ...

Dewalt DC925 Clutch Ring Jammed I have a new (1 week old) DC-925 hammer drill. The main issue.... the clutch ring is jammed. I am not sure when it happened, or if it was always that way. I have only ...

...off the pcb inside Hi, I have identified a component which has dropped of the main pcb inside my dewalt light, it is a dewalt dc527. It is called an inductor but I am unable to locate a part

dewalt 18 volt hammer drill. Mainly the gears. dewalt xrp Go to Dewaltservicenet.com and in the middle of the page towards the bottom type in your model number and it will take you to a page where the

the chuck does not open use antifreeze oil maybe stuck by rush be care full easy to lose its connection the plastic chuck to steel main chuck.

The three phillips head screws that hold the chuck section to the main portion of the drill have wiggled loose. How do I tighten them up / or how do I get the entire chuck section off to tighten them ...

...drill driver has striped one of the gears. When I take it apart, can I get a new gear to replace the damaged one? Thanks, Don Orr You bet you can order new parts. Here is the main page ...

How do you release the bits to change sizes It is a keyless chuck. You should be able to grab the main body of the chuck and turn it to the left to release the bit. You can also hold the main body of ...

how do I take a bit out? It is a keyless chuck. Put the drill in reverse (chuck should spin to the left when viewed from the back) and hold the main body area of the chuck with your hand while slowly ...

...drill working pull on mains cable. Not unheard of there being a break in the wiring around cable clamp of tool it can give similar results to what you describe. Have seen a drill work flat on bench, ...