...kit you have to activate developer in the service menu, then turn off the printer and then back on to run the developer unit up. Print menumap from the printer and follow through to the service area ...
kit but can not get the install mk message to reset. How do i reset it and get the message to disappear? Hi Did you run up the developer unit? Menu button down to Other then to Service and press enter
...kit Hi, This message is for Box A, which is consist of Developer and Drum. If your copy quality is good keep using it. but if you don't like the red light then you have to replace the Kit A. New kit ...
components (Drum, Developer, Transfer Roller, ETC) MK is tha maintenance kit, when the copier counter pass250k or somtimes 500k depends on the type of the copier, it ask for MK, to renew all the parts
kit is belongs to drum ,developer , drive gears ..... after 250000 print it asking to replace all the things ....... this is not harmful the printer it will work fine don't worry about the install mk.
...kit, or you sell the printer "as is" on eBay, after buying a new printer. You can continue to use the printer with the Install MK message showing untill one of the consumable parts fails.The ...
Question about MAINT KIT: DRUM, DEVELOPER, FEED & FUSER ASSEMBLIES - MK68 Maintenance / Upgrade Kit
...kit. If the problem is exist after the reinstallation of printer software.For this call us +61-1800-431-295. We will provie you better solution regarding this. Don't waste your time on searching ...
kit please reply fast u 16 usually refers to no developer installed. Open the front door and remove the waste container. Remove 1 screw and remove developer connector cover. Make sure plug id properly
photocopy print too faint developer unit has to run up via simulation 130 in service mode after kit is installed. or check installation of Transfer roller assy.
...kit is the developer and also the drum unit, you will need to change the 1/8th amp fuse in the developer assembly, and also the chip inside the drum unit. Farnell stock both, the fuses are p/n: ...
Usually answered in minutes!
2,817 Questions
2,244 Questions
2,162 Questions
2,149 Questions
1,912 Questions