AmanaD545M Runs but no water comes out Took the back off. The compressor is running but is extremely hot. Coils are warm. Is the compressor bad. The appliance is less than 3 years old and only used ...
plug it back in and power it up. When it shuts down, feel the compressor. It should be warm to the touch, but definitely not so hot that it singes your fingers. If you find that the compressor is just
Humidifer is not taking out water. Is there a start capacator for the compressor? This could be one of several things, we are assuming the air is humid. If the fan is not running and the compressor is
...dehumidifier which says it`s a Refridgerant,does it means it`s like an airconditioner?If so how do you use it nothing on the manual to illustrate & do you fill it with water first? Thanks regards ...
...dehumidifier without the filter installed. Once the filter has dried, reinstall it. Plug the unit back in and Turn the Master ON/OFF Switch to ON. If necessary, you can reset the settings, you ...
...plug it, before removing the filter. You can either vacuum the filter or if it's really dirty, wash it in warm water and dish washing liquid, rinse and thoroughly dry it, before reinstalling it. ...
...plug it in, and it begins to take an electrical load it blowes the fuse in the electrical panel. Does the unit sound normal? Does it appear to be getting warm? More than likely the ...
Question about General Electric 65-Pint Dehumidifier ADEW65LP
GE Humidifier smells terrible We bought a GE humidifier [ADEW 65]. It does a great job of getting moisture out of the air. After about a week, it started smelling terrible!. I removed the bucket and ...
...Plug the dehumidifier in to the wall outlet and set the fan switch to on - the fan will run (no compressor). Run this way for one hour to defrost the evaporator. Now adjust the humidity dial to your ...
Question about Santa Fe Dehumidifier
Plug the dehumidifier back in and turn it on. If the water level indicator still shows 50%, try pressing and holding the "Water Level" button for 3-5 seconds to reset the sensor. If the issue persists
Usually answered in minutes!
312 Questions
314 Questions
258 Questions
200 Questions
154 Questions