Question about Boss Dd-3 Digital Delay Pedal
...dd-3 pedal only works with a 9v battery. When I hook it up to the 9v apaptor, (a boss) it freaks out and does nothing. Can you help? Everything seems solid. the jack doesn't wiggle or anything. You ...
Question about Handycam DCR-VX2100 Mini DV Digital Camcorder
...I again have to connect the AC to get the camera going. Thoughts? this problem is by the DD board of the camcorder their is a power ic in the DD board,which provides the supply to the
Question about Handycam DCR-VX2100 Mini DV Digital Camcorder
DD board to need to take to the service center as their is allot minor soldering work to be done on the board. Superb Broadcast Equipmentv:* {behavior:url(#default#VML);}o:* {behavior:url(#default#VML
If it won't turn on, unplug power supply then use just the battery. 3. If these two steps doesn't work since you've already replace the battery and the power supply. You'll need to replace motherboard
...to amp, there is almost no signal (10% of usual) and sound is scratchy and fuzzy. what could this problem be? Most probable cause is low battery or defective power convertor if battery is not
Question about Boss Dd-3 Digital Delay Pedal
...is going on. First thing is to check that powr adapter is the correct one and/or battery is good. Light will come on with near dead battery or wrong power adapter... Wrong adapter can damage the
...DD-3 makes a strange tapping sound on all modes. tapping sound gets more frequent when i turn the delay time pot to the right. its like a little tap sound getting into the circuit with the guitar ...
...Dd you have a uninterruptible power supply? If not, and if the server receives no power at all it is likely it has taken a surge. You may need a new power supply, or the entire motherboard might be ...
...DD-2 pedal. I have put in a new 9V battery and it worked ok. When I finished playing, I turned everything off. Later, when I came back to play again, the battery had drained on the pedal. I replaced ...
Just checking to make sure the voltage on the power supply matches is not enough. You need to make sure that the miliamps match AND that the polarity is correct. I had the same issue with my old DD-20
Usually answered in minutes!
297 Questions
192 Questions
155 Questions
161 Questions
136 Questions